110mm Ring Seal Soil Pipe Air Admittance Valve - External

Specifications

Application Type: 110mm Ring Seal Soil System
Product Type: Air Admittance Valve
Connection Type: External
Brand: FloPlast
Width: 241.4mm
Depth: 241.4mm
Length: 282.8mm
Material: PVCu
Standards: BS EN 12380:2002, Kitemark No. KM 512474

This External Air Admittance Valve is designed to allow the free entry of air into a sanitary pipework system without the escape of foul gasses into the building. It also allows the installation of an external soil pipe within 3 metres of any opening. It terminates at the same height as if it were installed internally, i.e. 200mm (minimum) above the highest wet entry point to the soil vent pipe.

Product Features at a Glance:

• Fitted with an environmental mesh to reduce the risk of insects and environmental debris ingress.
• Product is A1 tested and approved in accordance with BS EN 12380.
• Can be installed below the flood level of connected appliances.
• Tested and approved for use between -20c and +60c without the use of insulation.
• Can be used as an additional secondary rodding point.
• Compatible with all UK 110mm plastic soil systems manufactured to BS EN 1329-1 or BS EN 1453-1.
• Push-fit installation to 110mm pipe or solvent weld to 82mm pipe.
• Must be installed vertically.
• CE and Kitemarked to BS EN 12380 (KM512474).

Manufacturers Advice: All valves should be stored/installed in an upright position. Approved Document H of the Building Regulations only permits Air Admittance Valves that conform to BS EN 12380. Ventilation and access must be provided to all air admittance valve installations.

FloPlast Soil & Waste Systems

Since its foundation in 1991, FloPlast has established itself as a manufacturer of high quality plastic building and plumbing systems for the construction industry, in particular domestic and commercial new build and refurbishment projects.

They offer an extensive choice of systems and products, in a range of sizes and colours, to suit all tastes and applications. Their Soil & Waste Systems offer a comprehensive, integrated and modern range of products for all soil and waste applications.

Features & Benefits

• Components have a consistent high gloss finish and colour and are essentially maintenance free.
• Tough and durable, yet lightweight for ease of installation.
• Compatible with most other existing materials and systems manufactured to British/European Standards.
• Manufactured to British/European Standards specification where applicable.
• Colour matching between systems facilitates colour coordination where sanitary pipework is located externally.

Working Temperature

FloPlast's Soil & Waste Systems may be used to carry liquids, when subjected to a continuous flow, with a maximum temperature of 76 degrees C. Intermittent discharges of up to 100 degrees C may occur, provided that a duration of less than two minutes is observed.

Pipework Support (BSEN 12056:2000 Maximum distances for support)

Size              Vertical            Horizontal

32mm            1.2m                  0.5m

40mm            1.2m                  0.5m

50mm            1.2m                  0.6m

110mm          2m                     1m

Please Note: All images shown are used for illustration purposes only and may differ from the actual product supplied.