2780m2 Clearwater Full Retention Separator

Specifications

Drainage Area: 2780m2
Flow: 50 litres/sec
Silt Capacity: 5,000 litres
Oil Capacity: 500 litres
Length: 5425mm
Diameter: 2010mm
Base to Inlet Invert: 1810mm
Base to Outlet Invert: 1760mm
Min Inlet Invert: 1000mm
Standard Pipework Diameter: 315mm

Clearwater Separators take oil, chemicals and solids from surface water to ensure they don’t pollute the surrounding environment and water course. Full Retention Separators are used for areas where the full flow of surface water needs to be treated before it reaches the environment. Unlike its Bypass counterpart, this system is therefore able to treat the full flow of surface water drainage.

The 2780m2 Clearwater Full Retention Separator is constructed out of Glass Reinforced Plastic (GRP), this means it is light for onsite handling and easy to install on site. The design is Class 1 as required for discharge to any surface water.

Areas where this separator may be used include:

• Scrap yards
• Fuel distribution depots
• Vehicle workshops

Key Features & Benefits:

• Light and easy to install
• Fitted inlet/outlet connectors
• Vent points in necks
• Maintenance from ground level
• BSI certified flow and performance to ensure it meets quality requirements of EN858-1
• Oil alarm system available (required by EN 858-1 and PPG3)
• Mains Separator Alarm
• Solar Powered Separator Alarm
• Extension access shafts for deep inverts available
• Meets the necessary volume requirements for:
• Oil separation capacity
• Silt storage capacity
• Oil Storage Volume
• Coalescer
• Automatic closure device

Please Note: all images are used for illustration purposes only and may differ from the actual product supplied.