69444m2 Klargester Bypass Separator

Specifications

Flow: 125 litres/sec
Peak Flow Rate: 1,250 litres/sec
Drainage Area: 69444m2
Silt Storage Capacity: 12,500 litres
Oil Storage Capacity: 1,875 litres
Length: 9548mm
Diameter: 1920mm
Access Shaft Diameter: 600mm
Base to Inlet Invert: 2235mm
Base to Outlet Invert: 2035mm
Standard Fall Across: 200mm
Min Inlet Invert: 950mm
Standard Pipe Diameter: 750mm

Klargester Bypass Separators remove contaminants, such as oil, chemicals and solids, from surface water to make sure they don’t pollute the nearby environment.

This 69444m2 Bypass Separator is constructed from Glass Reinforced Plastic (GRP), making it light and easy to handle on site. It comes complete with fitted inlet and outlet connectors and vent points in the neck. Maintenance is accessible from ground level, making it quicker and easier in upkeep. The design is Class 1 (required for discharge to any surface water) and the tank is CE-marked!

Key Features:

• Light and easy to install
• Inclusive of silt storage volume
• Fitted inlet/outlet connectors
• Vent points with necks
• Oil alarm system available (required by EN 858-1 and PPG3)
• Mains Separator Alarm
• Solar Powered Separator Alarm
• Extension access shafts for deep inverts available
• Maintenance from ground level

The bypass design is only suitable when it is considered acceptable to not treat water travelling at higher flow rates, i.e. storm water, meaning there would have to be minimal chance of a spillage and heavy rainfall occurring at the same time. Faster flowing storm water, i.e. above approx. 6.5mm/hr of rainfall, will pass through the system, bypassing the main separator chamber.

Typically this type of separator is installed in:

• Surface Car Parks
• Roadways
• Lightly contaminated commercial areas

Within the main chamber of this system there is capacity for:

• Oil separation
• Coalescer
• Oil storage volume
• Silt storage

Please Note: all images are used for illustration purposes only and may differ from the actual product supplied.