170mm Xtraflo 90dg Gutter Angle

Specifications

Application Type: Rainwater Gutter
Profile Type: 170mm XtraFlo
Product Type: Gutter Angle
Angle: 90-degrees
Brand: FloPlast
Width: 275mm 
Depth: 128mm
Length: 275mm
Material: PVCu
Standards: Manufactured to BS EN 607
                      Kitemarked - KM501316

This 170mm XtraFlo 90-degree gutter angle is designed to create a 90-degree bend, either internal or external, in an XtraFlo gutter system. It forms part of an XtraFlo guttering system that utilises a vortex outlet design to promote a vacuum effect that increases flow rates. Easy to install with enhanced flow capacity and a 10-year performance and colour guarantee.

Product Features at a Glance:

• Semi-Elliptical profile.
• Clip system for fast & easy installation.
• Changes the direction of a gutter through 90 degrees.
• Available in multiple colour options.
• FloPlast 10-year colour and performance guarantee
• Covered by BSI Kitemark – no. KM501316.
• Manufactured to BS EN 607 standards.

Manufacturer’s Advice: FloPlast recommend the use of lubricant on all gutter seals for ease of fitting and improved performance. Fascia brackets should be installed at a maximum of 1m apart along each gutter length and within 150mm of any other joint or fitting. 

FloPlast XtraFlo Guttering System

FloPlast is a well-established manufacturer and supplier of Plastic Building and Plumbing systems to the UK construction sector. They specialise in Roofline products with an extensive range of Rainwater systems, including the XtraFlo gutter.

Features & benefits

• Ideal for commercial, industrial and agricultural buildings.
• Suitable for any building with a large roof area.
• The vortex outlet design encourages the `swirling effect` of the water for greater water flow down the pipe.
• Complete with wide rubber seals which allows for optimum performance in all conditions.
• Innovative and clean modern appearance.
• Connects to 110mm pipe and fittings.
• System is covered by a BSI Kitemark – no. KM501316.
• Silicone lubricant must be used on all installations.

Gutter Flow Rates

With a max flow rate of 5.58 litres/sec for a gutter system installed with a 1:350 fall ratio (3.87 l/s if installed level), the Niagara Ogee gutter system, connected to a 110mm round downpipe via a stopend outlet, is suitable for a maximum roof area of 267m2 (185m2 if installed level).

With a max flow rate of 10.62 litres/sec for a gutter system installed with a 1:350 fall ratio (7.38 l/s if installed level), the Niagara Ogee gutter system, connected to a 110mm round downpipe via a running outlet at the centre of the gutter run, is suitable for a maximum roof area of 509m2 (354m2 if installed level).

System Standards
FloPlast’s XtraFlo guttering products are designed and manufactured to the following standards:

• BSI Kitemark number: KM 501316 – BS EN 607, BS EN 12200 and BS EN 1462 Plastic rainwater, piping and guttering systems for above ground use – Unplasticized poly vinyl chloride (PVC-U.
• BS EN 607 – Eaves gutters and fittings made of PVC-U.
• BS EN 1462 – Brackets for eaves gutters.
• BS EN 12200-1 – Plastics rainwater piping systems for above ground external use. Unplasticized poly (vinyl chloride) (PVC-U).
• BS EN 681 – Elastomeric seals. Material requirements for pipe joint seals used in water and drainage applications. Thermoplastic elastomers.

Please Note: All images shown are used for illustration purposes only and may differ from the actual product supplied.