13890m2 Clearwater Bypass Separator

Specifications

Flow: 25 litres/sec
Peak Flow Rate: 250 litres/sec
Drainage Area: 13890m2
Silt Storage Capacity: 2500 litres
Oil Storage Capacity: 375 litres
Length: 3575mm
Diameter: 1420mm
Access Shaft Diameter: 750mm
Base to Inlet Invert: 1680mm
Base to Outlet Invert: 1580mm
Standard Fall Across: 100mm
Min Inlet Invert: 700mm
Standard Pipe Diameter: 375mm

Clearwater Bypass Separators separate oil, chemical or solids from surface water to ensure they don’t pollute the surrounding environment and water course. This 13890m2 Bypass Separator is constructed out of Glass Reinforced Plastic (GRP). This means it is light for onsite handling and easy to install. The design is Class 1 as required for discharge to any surface water.

Key Features:

• Light and easy to install
• Fitted inlet/outlet connectors
• Vent points with necks
• Maintenance from ground level
• Oil alarm system available (required by EN 858-1 and PPG3)
• Mains Separator Alarm
• Solar Powered Separator Alarm
• Extension access shafts for deep inverts available
  
• CE-marked

This type of system is suitable in areas that it is considered acceptable to not provide treatment for higher flow rates, i.e. storm water, meaning there would have to be very little chance of a spillage and heavy rainfall occurring simultaneously. This is necessary as anything above 6.5mm/hr of rainfall will bypass the main chamber of the separator.

Typically this type of separator is installed in:

• Surface Car Parks
• Roadways
• Lightly contaminated commercial areas

Within the main chamber of this system there is capacity for:

• Oil separation
• Coalescer
• Oil storage volume
• Silt storage

Please Note: all images are used for illustration purposes only and may differ from the actual product supplied.